30 May 2004
To: ALL
- Dahlgren System 300 Manual Pdf
- Dahlgren System 300 Manual Instructions
- Dahlgren System 300 Manual Software
- Dahlgren System 300 Manual
30 May 2004
To: UncleSteve [#1] 30 May 2004
DGL Engraving
Port Hueneme, CA
30 May 2004
To: Stunt Engraver (DGL) [#2] 30 May 2004
Dahlgren System 300 Manual Pdf
30 May 2004
To: UncleSteve [#3] 30 May 2004
DGL Engraving
Port Hueneme, CA
30 May 2004
To: Stunt Engraver (DGL) [#4] 30 May 2004
30 May 2004
To: UncleSteve [#1] 30 May 2004
Dahlgren System 300 Manual Instructions
30 May 2004
To: Harvey only (HARVEY-ONLY) [#6] 31 May 2004
31 May 2004
To: UncleSteve [#7] 31 May 2004
31 May 2004
To: ALL
Dahlgren System 300 Manual Software
The Wizzard (XL)is an amazing machine. They just keep on plodding along year after year. We use one as a backup machine and for doing repetitious jobs such as medals. Ours regularly does 4 to 500 medals a week without a hitch and I find the engraving of small characters to be immaculate. As it's not Windows-based the slow computer hardware is a bit painfull, but it's a great example of engineering for its time. I don't think we've ever used the rotary aspect, but it is a great second or third machine even now, and you can't kill it with an axe.31 May 2004
To: Harvey only (HARVEY-ONLY) [#8] 31 May 2004
31 May 2004
To: UncleSteve [#11] 31 May 2004
31 May 2004
To: UncleSteve [#11] 31 May 2004
DGL Engraving
Port Hueneme, CA
Back to thread list | Login
Dahlgren System 300 Manual
© 2020 Project Beehive Forum
We Have Parts in Stock for ALL Dahlgren and Suregrave Engraving Systems from System One to 600SEZ. All our parts are Original Factory Replacement Parts and Come with the Full Manufacturers Warranty. Call Toll Free 1-888-DNK-FIXX or email for prices [email protected]
Spindle Motors | Motor Belts | Cutter Blades |
Spindles | Chip Removal | Pulley Bearings |
Keyboard Overlay | Keyboards | Leadscrew Nuts |
System I / II | 150/300/400 MB/SE/SEZ |
Does your Wizzard II / XL or Mark 12 Need Service? We are only one of Two Places that have the Jig Fixture to Square and Align your Frame. Don't be fooled by so call offers to tune-up or clean your Wizzard. To Properly clean and set the preload on the Leadscrew nuts they have to realign the Frame. If ANYONE REMOVES the Bridges your Spindle or Clamp Bars are attached to your Wizzard will no longer be Square. If you want a second opinion then Call Dahlgren's USA Service Center and ask them. Anyone who has been trained at the Factory will know this. AS we were a Factory Authorized Service Center at one time we had a Machine Shop make this Jig Fixture based on the ONLY ONE the Factory Owned, This Fixture is now at their Service Center in Oakland, Ca. So if someone tell you they are servicing your Wizzard, ask them to provide photos of your Wizzard torn down to the bare frame and them rebuilt. Look at the Photos from some of the work we have done.